This antenna connects directly to your radio — no adapter needed. This is a direct-fit antenna only and does not work with Signal Strand™.

For radios with an abnormally long SMA base, this is just a rubber washer that fits snugly around the connector and fills the gap between the radio and the antenna.

Adds a connection point for the Signal Strand™ wire (sold separately), which enhances the antenna system and greatly improves performance for both transmit and receive! It also adapts your radio to use BNC antennas.

A ready-to-use, flexible 18 AWG silicone-insulated wire that attaches to any Signal Strand™ adapter to improve antenna balance and enhance both transmit and receive performance.

Use this BNC antenna with a Signal Strand™ adapter. Add a Signal Strand™ wire if you want the full counterpoise setup.

For radios with an abnormally long SMA base, this is just a rubber washer that fits snugly around the connector and fills the gap between the radio and the antenna.

Relocates any BNC antenna outside your vehicle in seconds. Connects to any BNC-equipped radio, BNC adapter, or Signal Strand™ adapter.

Allows you to use a BNC antenna with your radio. Great for standardizing on BNC, quick antenna swaps, and reducing wear on the connector. If you want to attach a Signal Strand™ wire, use the Signal Strand™ adapter instead.

Use this with the SMA-M to BNC-F adapter to use with your radio! Also works great on the BNC Mag Mount.

For radios with an abnormally long SMA base, this is just a rubber washer that fits snugly around the connector and fills the gap between the radio and the antenna.

Relocates any BNC antenna outside your vehicle in seconds. Connects to any BNC-equipped radio, BNC adapter, or Signal Strand™ adapter.

For a radio that normally takes BNC, this will let you connect an antenna with an SMA-M connector. Can also be used to connect your Icom or Yaesu antenna to a BNC Mag-Mount.

SignalStuff Exclusive! This solid adapter allows you to connect an SMA-F antenna to a radio which normally takes an SMA-M, such as most Icom, Yaesu, or Kenwood radios.

This is the SMA connector that screws into the radio. The plastic cover screws down snug on most handhelds. Fits most Baofeng radios.

For radios with an abnormally long SMA base, this is just a rubber washer that fits snugly around the connector and fills the gap between the radio and the antenna.

This black solid metal adapter fits your PL-259 coax to connect to a BNC adapter or a radio which takes a BNC antenna.

Allows you to use the SO-239 adapter with your radio.

For radios with an abnormally long SMA base, this is just a rubber washer that fits snugly around the connector and fills the gap between the radio and the antenna.